DOT 4 Full Synthetic Brake Fluid

DOT 4 Full Synthetic Brake Fluid is a moisture resistant full synthetic high performance brake fluid based on glycols with corrosion inhibitors. It meets the latest Australian and International standards and is fully miscible and compatible with almost every fully synthetic brake fluid except DOT 5.1.

HANDLING & APPLICATION

DOT 4 Full Synthetic Brake Fluid maintains absolute cleanliness when handling brake components. Avoid contamination with other fluids and use only brake fluid for flushing the system. Reseal all containers and cap reservoirs immediately as atmospheric moisture will lower the vapour lock/boiling point and noticeably reduce performance.Fluids not complying with Australian Standard 1960 – 1983 Grade 3 should not be mixed with DOT 4 Full Synthetic Brake Fluid because the boiling point and low temperature properties may be adversely affected.

If mixed, the brake system must be drained and refilled with fresh Brake Fluid as soon as possible. Fill with fresh fluid every 12 months to maintain a high vapour lock/boiling point for best performance and to minimize corrosion.

SPECIFICATION

DOT 4 Full Synthetic Brake Fluid meets or exceeds the following specifications:

  • AS/NZ 1960.1: 1995 Grade 3, Brake Fluids (non-petroleum types)
  • ISO 4925 Class 4
  • SAE J 1703
  • FMVSS 116 DOT 3 and DOT 4
  • Ford ESW-FM6C-2, ESZ-M6C-55A
  • GMH HN 1796

PACKAGING

20 Litre drums

TYPICAL MAIN CHARACTERISTICS

CHARACTERISTICS DOT 4 Full Synthetic Brake Fluid

Density at 20°C

1.064

Kinematic Viscosity at 40°C, mm2/s (cSt)

980

Boiling Point, ERBP (Typical)

265

Wet Boiling Point, Wet ERBP (Typical

165

 

NOTE: Due to continual product research and development, the information contained herein is subject to formulation change without notice.

Values stated are average values only and may vary due to manufacturing tolerances.